Модуль реле 8-канальный с оптопарой - контакты 10A/250VAC - катушка 5V - красный

• The supply voltage VCC: 5 V
• It is enabled by the high state: min 3.3 V
• Relay SRD-05VDC-SL-C (documentation)
  • Coil voltage: 5 V
  • The maximum voltage of contacts: 250 V AC, 110 VDC*
  • Maximum current: 10 A
• Optoelectronic isolation
• 8 leds
  • 7 - signaling the activation of relays
  • 1 - signaling the power connection
• Tile sizes 139 x 55 mm
• Weight: 118 g
• Diameter of mounting holes: 3 mm

* Maximum contact voltage depends on the type load - details inthe documentationtab. 7. Contact Rating.

The module allows to control the actuators consuming the current up to 10 A using the microcontroller's ports or any starting set (includingArduino,Rasbperry PiandSTM32Discovery). Optoisolation seperates the control signal from the part associated with the power of relay, thereby providing safety of the controlling system's work.

The product is compatible with Arduino

For relay control, a digital control signal from leads of the Arduino is enough.

For proper operation, it is sufficient to connect the power of relay's coil and the digital control signal. Leads are the standardstrap goldpin with pitch of 2.54 mm which eneable the connection by the connecting cables.

The relay has the following leads

• VCC- power of optoisolation
• GND- mass of system
• IN1 ... IN8 - control inputs of relays, activated by high state
• Jumper COM GND - connect the system masses with the mass of optoisolation
• Connectors KF (ARK)- the relay contacts are connected in accordance with the pattern on plate of the module.

• Driver of lighting
• The driver of executors
• Switch for electric devices, including motors

• Documentation of the relaySRD-05VDC-SL-C(.pdf)

• Example of connecting a relay to the Raspberry Pi